OP Amp Circuits Mcqs
Q.1: Calculate the cutoff frequency of a first-order low-pass filter for R1 = 2.5k and C1 = 0.05F___________?l
A. 1.273kHz
B. 12.73kHz
C. 127.3 kHz
D. 127.3 Hz
Q.2: The closed-loop voltage gain of an inverting amplifier equal to______________?N
A. The ratio of the input resistance to feedback resistance8
B. The open-loop voltage gain
C. The feedback resistance divided by the input resistance7
D. The input resistance
Q.3: A non inverting closed loop op amp circuit generally has a gain factor______________?U
A. Less than one
B. Greater than one
C. Of zero
D. Equal to one
Q.4: An ideal OP-AMP is an ideal______________?*
A. Current controlled Current source!
B. Current controlled voltage source!
C. Voltage controlled voltage source!
D. voltage controlled current source!
Q.5: If ground is applied to the (+) terminal of an inverting op-amp, the () terminal will_____________?f
A. Not need an input resistor
B. Be virtual ground
C. Have high reverse current
D. Not invert the signal
Q.6: The ideal OP-AMP has the following characteristics2
A. Ri= ,A= ,R0=0
B. Ri=0 ,A= ,R0=0
C. Ri= ,A= ,R0=
D. Ri=0 ,A= ,R0=
Q.7: How many op-amps are required to implement this equationop-amps?@
A. 2
B. 3
C. 4
D. 1
Q.8: How many op-amps are required to implement this equation Vo = V1?A
A. 4
B. 3
C. 2
D. 1
Q.9: An ideal OP-AMP is an ideal__________?&
A. Current controlled Current source!
B. Current controlled Voltage source!
C. Voltage controlled Voltage source!
D. Voltage controlled Current source!
Q.10: An amplifier using an opamp with slew rate SR=1v/sec has a gain of 40db.If this amplifier has to faithfully amplify sinusoidal signals from dc to 20KHz without introducing any slew-rate induced distortion, then the input signal level exceed_____________?
A. 795mV
B. 395mV
C. 795mV
D. 39.5mV

Related Mcqs

All Subject Mcqs